Manufactured Treatment Devices¶
A manufactured treatment device (MTD) is a proprietary stormwater-treatment unit. Chapter 11.3 describes hydrodynamic sedimentation devices, which settle pollutants, and filtration devices, which pass runoff through media. GI devices are addressed separately in Chapter 9.5. Manual 11.3, p. 1
Chapter 11.3 devices provide water-quality treatment, with a certified TSS-removal rate of either 50% or 80%. They have no GI, recharge or quantity credit under this chapter. TSS means total suspended solids. Manual 11.3, p. 1
Obtain the NJDEP certification letter and NJCAT verification report for the exact model. Know the contributing area, Water Quality Design Storm (WQDS) peak flow and installation space before selecting it. Install the configuration used for verification. Manual 11.3, p. 1 Manual 11.3, p. 3
For an 80% filtration device, evaluate both maximum allowable drainage area and maximum treatment flow and choose the configuration that satisfies both. A 50% hydrodynamic device is sized by treatment flow. Use the certificate's model tables and conditions. Manual 11.3, p. 5
Quality use follows the chapter's waiver/variance entry and the rule's selection conditions. Certification establishes the device performance, while the project still has to meet those selection conditions. Manual 11.3, p. 1 N.J.A.C. 7:8-5.3
Use the model's required separation from seasonal high water table (SHWT); Chapter 11.3 does not supply one distance for every device. Provide watertight joints, the required structural loading capacity, safe overflow and maintenance access. Downstream connections must remain accessible for inspection. Manual 11.3, p. 3
Inspect structural components at least annually and sediment- and debris-catching components at least twice a year and after storms exceeding 1 inch. The maintenance plan must set allowable oil, sediment and debris accumulation levels, with removal when those limits are reached. Follow the manufacturer's additional maintenance requirements. Manual 11.3, p. 5 Manual 11.3, p. 6
Check standing water against the intended device design. If standing water is not part of that design, correct the problem and revise the maintenance manual. Manual 11.3, p. 6
The wrong model or layout is used. A similar product name, altered inlet or different pipe arrangement does not establish verified performance. Compare the installed unit with the certificate and tested configuration. Manual 11.3, p. 1 Manual 11.3, p. 3
Treatment capacity is exceeded. Include the full contributing WQDS flow, especially for an outfall retrofit. Future connections cannot exceed the selected unit's maximum treatment flow. Manual 11.3, p. 3 Manual 11.3, p. 5
Source chapters: January 2026 · Earlier collection. Check the date printed on the chapter when comparing editions.
N.J.A.C. 7:8-5.2(j) requires NJCAT verification and NJDEP certification of device pollutant-removal rates. This library does not assign approval to an unnamed model.
N.J.A.C. 7:8-5.3 sets the GI selection requirements and exceptions; N.J.A.C. 7:8-5.8 covers maintenance plans for major development.